Cisco Catalyst 1000-8P-2G-L Network Switch, 8 Gigabit Ethernet (GbE) PoE+ Ports, 670W PoE Budget, two 1 G SFP/RJ-45 Combo Ports, Fanless Operation, Enhanced Limited (C1000-8P-2G-L)

Product Information

The software features supported on the Cisco Catalyst 1000 Series can be found on Cisco Feature Navigator: https://cfn.cloudapps.cisco.com/ITDIT/CFN/jsp/by-feature-technology.jsp. Catalyst 1000 series Fast Ethernet models are available with LAN Lite equivalent feature set only. Fast ethernet provide reduced functionality and scalability compared to the Gigabit ethernet models and are targeted for deployments with basic requirements.

Peel the adhesive strip off the bottom of the screw template, and attach it to the top of the desk or shelf. Unidirectional Link Detection Protocol (UDLD) and Aggressive UDLD allow unidirectional links caused by incorrect fiber-optic wiring or port faults to be detected and disabled on fiber-optic interfaces.To prevent ESD damage, follow your normal board and component handling procedures when connecting cables to the switch and With auto-MDIX, the switch detects the required cable type for copper Ethernet connections and configures the interface accordingly. inside the chassis, which can result in system malfunction. You must install this equipment in an environment as free from

use your finger, use a small, flat-blade screwdriver or other long, narrow instrument to open the latch. The AC frequency range of the power supply is 50Hz/60Hz. Plug the AC power cord into the AC power connector and into an AC

Compare Catalyst 1000 models

To prevent airflow restriction, allow clearance around the ventilation openings to be at least: 3 inches (7.6 cm). Statement 1076 without a value, the time delay appears in the running configuration file with an explicit timer value of 4 minutes. Ultimate disposal of this product should be handled according to all national laws and regulations. Statement 1040 are located within a restricted access location and users and service people who are authorized within the restricted access

Device management support with over-the-air access via Bluetooth, Simple Network Management Protocol (SNMP), RJ-45 console access TACACS+ and RADIUS authentication to facilitate centralized control of the switch and restrict unauthorized users from altering the configuration. IP Source Guard to restrict IP traffic on nonrouted Layer 2 interfaces by filtering traffic based on the Dynamic Host Configuration Protocol (DHCP) snooping binding database or by manually configuring IP source bindings. Use Cisco Feature Navigator to find information about platform support and Cisco software image support. To access Cisco Feature Navigator, go to www.cisco.com/go/cfn. An account on Cisco.com is not required. Table 4. Feature Information for Single IP Management

For partners

The Cisco Catalyst 1000 Series Switches that support 1-G and 10-G SFP and SFP+ uplink ports can be part of single IP management. ports do not support autonegotiation, you can manually set the speed and duplex parameters. Connecting devices that do not Position the switch directly in front of the DIN rail, making sure that the top of the DIN rail mount clip hooks over the Ensure that power is removed from the switch, and disconnect all cables and connectors from the front panel of the switch. To prevent the system from overheating, do not operate it in an area that exceeds the maximum recommended ambient temperature